shear造句

In general, the deformation of the model grille is a combination of axial and shear strains.
一般情況下, 模型柵格的變形是軸向應變和切向應變的組合.

Ambitious attempts to improve interlaminar shear strength have been made by Mueller Prosen and by Keogh.
米勒·普羅森還有基奧都對提高層間切變強度作了大膽的嘗試.

There may be widespread changes in ground elevation as well as horizontal or shear displacements.
地面標高可能發(fā)生廣泛的變動,也可能發(fā)生水平位移或剪切位移.

For any load the function from load is in multiplication shear force by antisymmetry load.
任意荷載的作用含反對稱荷載分量的圖乘剪力的作用.

Textbooks commonly denote shear stresses by the symbol and two subscripts.
教科書通常用符號和兩個腳標表示剪應力.

Shear force is interrelating with width and thickness of plate and obliquity of knife - edge.
斜刃剪切時,剪切力的大小與板料的寬度、厚度及斜刃傾角有關.

Slitting knives are used to shear the fabric to a precise width.
橫切刀被用來將布剪裁到精確的寬度.

Abstract: Shear force is interrelating with width and thickness of plate and obliquity of knife - edge.
文摘: 斜刃剪切時,剪切力的大小與板料的寬度、厚度及斜刃傾角有關.

The paper analyes interation shear , fluid forming process , and discuss the ore forming mechanism.
并在此前提下提出了構造-流體-巖石相互作用的金成礦機理.

The results show that there exists shear deformation in lower bainite transformation.
研究表明,下貝氏體相變過程中必定存在切變.

In the Hebrides they shear their sheep later than anywhere else.
在赫伯里茲，剪羊毛的時間比其他任何地方都要晚。

The effects of secondary torsion on shear strength of biaxial flexural reinforced concrete beams are analyzed.
探討了次生扭矩對鋼筋混凝土雙向受彎梁抗剪承載力的影響.

As a result the FRP shear contribution may be over - estimated.
因此,以往的方法高估了FRP條帶的抗剪貢獻.

Sheet Metal , Metalworking Guillotine , Shear, Bend Shear , New , Used, Machinery Sheet Metal.
采購產(chǎn)品金屬板材, 金屬加工(剪切, 彎曲)機械鈑金.

Objective To study and shear bond strength of resin - reinforced glass ionomer cement ( RGIC ) on orthodontic brackets.
目的探討兩種樹脂加強型玻璃離子水門汀對托槽粘結強度的影響.

The interfacial shear stress is a constant proportion of the bottom shear.
交界面的剪力與底部剪力之比是常數(shù).

The pumps must be of the low shear Archimedes screw type.
泵必須是低剪切力的阿基米德螺旋式泵.

Without loss of generality, shear deformations will be neglected.
不失一般性, 忽略不計剪切變形.

Indirect Methods: To measure the interface bond strength include the interlaminar shear strength test.
測量界面粘結強度的間接方法包括層間剪切強度試驗.

The novel - flocculant poly - nucleate aluminum hydroxy silicate - sulphate ( PASS ) was prepared and polysilicic acid under non - high shear condition.
在非高剪切力條件下,將硫酸鋁引入到聚合硅酸中合成了新型聚硅酸硫酸鋁 ( PASS ) 絮凝劑.

• #shear